Timing Belt and water pump replacement
-
- Site Admin
- Posts: 3334
- Joined: Thu Sep 06, 2018 6:08 pm
- Has thanked: 61 times
- Been thanked: 89 times
Re: Timing Belt and water pump replacement
I think I have about 5 or 6 of the bloody things, but I can’t lay my hands on them until tomorrow at the earliest
Admin and Owner of this fine club
Re: Timing Belt and water pump replacement
Check that the tensioner is working ,or all the work will be for nothing.
-
- Tech Rep
- Posts: 2823
- Joined: Fri Sep 07, 2018 8:28 am
- Has thanked: 15 times
- Been thanked: 88 times
Re: Timing Belt and water pump replacement
The pin on the hydraulic shouldnt move in or out sounds like its knackered you usally need a vice
to push the pin in if it any good and you want to reuse it
to push the pin in if it any good and you want to reuse it
Re: Timing Belt and water pump replacement
And lastly , everyone needs to know this.
IF you over-tighten the screws that hold the tensioner in place and it snaps off in the engine block , I have the only piece of kit IN THE WORLD ,
that will allow you to remove the piece left in the hole.........without removing the engine.
Remember.
IF you over-tighten the screws that hold the tensioner in place and it snaps off in the engine block , I have the only piece of kit IN THE WORLD ,
that will allow you to remove the piece left in the hole.........without removing the engine.
Remember.
-
- Registered User
- Posts: 27
- Joined: Sun Feb 13, 2022 10:10 pm
- Has thanked: 3 times
- Been thanked: 1 time
Re: Timing Belt and water pump replacement
Finally after 5 attempts I have the correct water pump, I've fitted that, I'm about to fit the new cambelt tensioner but I've found a 12mm spring washer?? Does this go behind the tensioner, ?? I've bought a haynes manual but it hadn't arrived yet and I was hoping to fit tonight? Cheers Mark
-
- Registered User
- Posts: 84
- Joined: Tue Sep 11, 2018 5:00 pm
- Been thanked: 1 time
Who is online
Users browsing this forum: No registered users and 50 guests