Hi folks,
I'm still working on getting my '97 V6 Probe back on the road.
I need a passenger side rear ABS sensor which doesn't seem to be available in local motor factors.
Any idea where I could get one?
Thanks in advance.
Maria.
ABS problem
Re: ABS problem
There are only four ways these items can fail.
1/ By the stainless can being crushed by rust.
2/ The can being damaged on removal
3/ The 'sticky-out' peg being damaged by a stone, etc
4/ The cable being damaged
Which one caused yours to fail ?
1/ By the stainless can being crushed by rust.
2/ The can being damaged on removal
3/ The 'sticky-out' peg being damaged by a stone, etc
4/ The cable being damaged
Which one caused yours to fail ?
-
Micron
- Site Admin
- Posts: 3334
- Joined: Thu Sep 06, 2018 6:08 pm
- Has thanked: 61 times
- Been thanked: 89 times
Re: ABS problem
What are people's thoughts on this, it's for a Mazda MX6 (1997), about £26 delivered? (depending what postage option you go for)
https://www.rockauto.com/en/moreinfo.ph ... 2&jsn=5630
https://www.rockauto.com/en/moreinfo.ph ... 2&jsn=5630
Admin and Owner of this fine club 
-
Kit
- Tech Rep
- Posts: 3551
- Joined: Fri Sep 07, 2018 8:16 pm
- Has thanked: 71 times
- Been thanked: 115 times
Re: ABS problem
That’s interestingMicron wrote: ↑Tue Jun 28, 2022 3:13 pmWhat are people's thoughts on this, it's for a Mazda MX6 (1997), about £26 delivered? (depending what postage option you go for)
https://www.rockauto.com/en/moreinfo.ph ... 2&jsn=5630
When you think how hard they can be to remove the stub hub, without damaging them, it’s a bargain
Kit
Re: ABS problem
If all else fails I do have one BUT the cable is only 6 inches long.
It can be spliced onto the existing cable by twisting the wires together NOT SOLDERED.
I can supply all the heat shrinks to make it a good job.
A £3 postage stamp gets it to you.
It can be spliced onto the existing cable by twisting the wires together NOT SOLDERED.
I can supply all the heat shrinks to make it a good job.
A £3 postage stamp gets it to you.
-
david_toft
- Registered User
- Posts: 84
- Joined: Tue Sep 11, 2018 5:00 pm
- Been thanked: 1 time
Re: ABS problem
Because those cables are subject to LOTS of movement and vibration.
It has to be totally flexible.
The wire is much finer than hair , twisting them together is fine , solder and the wire will break on the solder/wire transition.
It has to be totally flexible.
The wire is much finer than hair , twisting them together is fine , solder and the wire will break on the solder/wire transition.
Who is online
Users browsing this forum: No registered users and 19 guests