Hey guys, failed MOT due to battery being insecure. I have no idea what the clamp that is missing looks like. is it the sort of thing i could fabricate? If anyone has a picture that would really help. Car is still at the garage so cant even have a look at the battery tray.
Just to add to this, its failed on both front control arm ball joint rubbers being split. What's the best way to go about this? try to find new boots or try to replace the ball joints?
thanks
Battery clamp and ball joints
Re: Battery clamp and ball joints
You can secure your battery with cable ties, this is perfectly acceptable to pass an MOT.
-
Incognito
- Full Member
- Posts: 2269
- Joined: Thu Sep 06, 2018 9:27 pm
- Has thanked: 48 times
- Been thanked: 18 times
Re: Battery clamp and ball joints
As Paul says, I do this every mot with mine and I have the proper clamp but cable ties are easier
Re: Battery clamp and ball joints
LISTEN UP.
I have replied to this type of failure many , many times.
When you fit your new wishbones you MUST fit a thin stainless steel washer between the rubber boot and the split clamp.
Because , if you don't , the gap in the clamp snags on the rubber and every time you turn left or right it twists the boot which is not good.
It will split and in no time wreck the ball joint.
I have replied to this type of failure many , many times.
When you fit your new wishbones you MUST fit a thin stainless steel washer between the rubber boot and the split clamp.
Because , if you don't , the gap in the clamp snags on the rubber and every time you turn left or right it twists the boot which is not good.
It will split and in no time wreck the ball joint.
-
Funokata
- Full Member
- Posts: 53
- Joined: Fri Apr 01, 2022 7:42 am
- Has thanked: 1 time
- Been thanked: 4 times
Re: Battery clamp and ball joints
Top tip jrh, thanks very much!
Whole new wishbones eh? Having looked up the ball joints looks like they're pressed in. I'll just go for whole new ones then!
Whole new wishbones eh? Having looked up the ball joints looks like they're pressed in. I'll just go for whole new ones then!
-
cpt black
- Tech Rep
- Posts: 2823
- Joined: Fri Sep 07, 2018 8:28 am
- Has thanked: 15 times
- Been thanked: 88 times
Re: Battery clamp and ball joints
You can press in new ball joints (ive done it) but if the Kurling inside is fuba the new joint will fail
asap as its all that holds it and will rotate, the nut just holds to the shock
asap as its all that holds it and will rotate, the nut just holds to the shock
Who is online
Users browsing this forum: No registered users and 37 guests