For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
-
Sunfly
- Full Member
- Posts: 1026
- Joined: Fri Sep 07, 2018 9:11 am
- Been thanked: 23 times
Post
by Sunfly » Tue Sep 11, 2018 6:44 pm
Donner1 wrote: ↑Tue Sep 11, 2018 3:21 pm
I pulled the connector behind glove box and cleaned it. Light has gone out for now.
I think you've sorted it. Code 33 is the passenger air bag and the circuit is very simple, just the airbab with its shorting bar and the joint connector you pulled. Connector is most likely as its know to be a common fault.
Happy motoring!
Bob.
-
Donner1
- Registered User
- Posts: 125
- Joined: Fri Sep 07, 2018 9:27 am
Post
by Donner1 » Tue Sep 11, 2018 8:17 pm
Many thanks for the help
-
Sunfly
- Full Member
- Posts: 1026
- Joined: Fri Sep 07, 2018 9:11 am
- Been thanked: 23 times
Post
by Sunfly » Wed Sep 12, 2018 7:21 am
Chris-A wrote: ↑Tue Sep 11, 2018 10:13 am
I have a similar problem. Code 33 seams to be Pin 7 not grounded at DM. What is DM ? Anyone
DM is Diagnostic Monitor (or module to us) and for 33 its looking for a resistance of 0.9 to 1.1 ohms across pins 9 and 11 when the ignition is turned to ON. Above 4 ohms and you get 33 flashing. I'd check the connector first as per Donner's post.
Good luck.
-
Meadlo
- Registered User
- Posts: 269
- Joined: Thu Sep 06, 2018 8:55 pm
- Has thanked: 1 time
Post
by Meadlo » Wed Sep 12, 2018 7:40 am
Will do. Fingers crossed
Who is online
Users browsing this forum: No registered users and 29 guests