what a nightmare...
Rear calipers sticking despite removal and clean up.
purchased two new calipers and had to provide old calipers as part payment.
so they are no longer in my possession.
fitted and adjusted the new replacement calipers and they seamed to work with the car elevated,
and also when put on the ground..
But
Failed MOT again.......
rolling road test said that passenger side was below required limits.
mechanic said that it initially held then would give way under load.
he tried it several times.
garage then replaced caliper with a replacement unit and same issue.
garage then replaced again with another new unit and same issue.
they said that the ford probe brake calipers had originally had a recall back in the day for this particular problem,
but with over 10 years of probe ownership i have never come across this.
Shout out to Duncan, ever heard of this one????
any how,
still no MOT.
i have a couple of other cars which i can try and swap out the caliper to try and get me back on the road.
but failing that the garage cant pass the car.
Car off the road because the handbrake wont hold on the rolling road,
but does on the ground??????????
All the UK supplies seam to be reconditioned....
would i be better going to rockautos, do they supply brand new?
suggestions welcome...
asap as i am off the road.....
all other MOT items have been done......
all the best
rear brake calipers.....MOT WOES
-
Micron
- Site Admin
- Posts: 3335
- Joined: Thu Sep 06, 2018 6:08 pm
- Has thanked: 61 times
- Been thanked: 89 times
Re: rear brake calipers.....MOT WOES
I would also go with the handbrake cable, I replaced them all on the white one and even then, the garage adjusted them some more as it didn't pass first time.
Admin and Owner of this fine club 
Re: rear brake calipers.....MOT WOES
Definitely go with a handbrake cable had these issues on a Swedish car moons ago
Re: rear brake calipers.....MOT WOES
many thanks peeps.....
was starting too think that way, well sort of...
if in doubt change it all out... lol
thanks Duncan,
funny you should say that...
the tester of my cars over the years liked the car, and has always given it a little wiggle room,
however he has since retired and the new guy likes the modern cars that his diagnostic tool tells him what he needs to do......
thanks again for all answers
best i get on it...
was starting too think that way, well sort of...
if in doubt change it all out... lol
thanks Duncan,
funny you should say that...
the tester of my cars over the years liked the car, and has always given it a little wiggle room,
however he has since retired and the new guy likes the modern cars that his diagnostic tool tells him what he needs to do......
thanks again for all answers
best i get on it...
Re: rear brake calipers.....MOT WOES
Don't buy that brake cables theory.
If the cables are intact, with no broken strands, then they should provide and sustain a sufficient ' pull' between handbrake lever fully down and less than fully up.
In fact, IF you can pull the handbrake lever fully up I would say you have a problem with the body anchoring points 'moving'.
So, back to calipers.
They are ,truly, the design of an evil genius.
IF they are in good condition AND the discs AND the pads are good/perfect, then the system works. Otherwise no.
You really have to look at every item on that list and put it right.
If the cables are intact, with no broken strands, then they should provide and sustain a sufficient ' pull' between handbrake lever fully down and less than fully up.
In fact, IF you can pull the handbrake lever fully up I would say you have a problem with the body anchoring points 'moving'.
So, back to calipers.
They are ,truly, the design of an evil genius.
IF they are in good condition AND the discs AND the pads are good/perfect, then the system works. Otherwise no.
You really have to look at every item on that list and put it right.
Re: rear brake calipers.....MOT WOES
An after dinner thought.
To get the rear calipers adjusted properly it is VITAL that the brake system is ABSOLUTELY free of air in the system.
Because to get that 1/4 turn back-off between discs and pads , lock-up/ off , is impossible if air is present.
Have you bled the system enough, to be sure ?
To get the rear calipers adjusted properly it is VITAL that the brake system is ABSOLUTELY free of air in the system.
Because to get that 1/4 turn back-off between discs and pads , lock-up/ off , is impossible if air is present.
Have you bled the system enough, to be sure ?
-
Incognito
- Full Member
- Posts: 2269
- Joined: Thu Sep 06, 2018 9:27 pm
- Has thanked: 48 times
- Been thanked: 18 times
Re: rear brake calipers.....MOT WOES
Mines in for test next month and its always handbrake, my garage adjusts its but leaves it off, one time test on mot it passes , but then after that it would fail.
Re: rear brake calipers.....MOT WOES
all i can say is that i have had four reconditioned calipers on the car now,
one bled and adjusted by me, and i thought it worked okay,
but i dont have a rolling road.
Garage has fitted the other 3 and wont pass the car.
i can only assume that they are doing it right?
as said try to eliminate every thing.
i have brand new cables on order.
mid, left and right.
i have replaced both calipers,
i have fitted new pads.
will fit a different caliper, bleed it all and see if the garage will pass that one.
will post up results...........
one bled and adjusted by me, and i thought it worked okay,
but i dont have a rolling road.
Garage has fitted the other 3 and wont pass the car.
i can only assume that they are doing it right?
as said try to eliminate every thing.
i have brand new cables on order.
mid, left and right.
i have replaced both calipers,
i have fitted new pads.
will fit a different caliper, bleed it all and see if the garage will pass that one.
will post up results...........
Who is online
Users browsing this forum: No registered users and 16 guests