The heater temperature control lever on my Probe feels loose, there is no feeling of resistance when moving the lever. The temperature from the heater is stuck on slightly warm. It seems like a cable has snapped.
So were to i start? Do I have to take the heater out completely or can I take the front panel off.
Any advise we be gratefully received.
Thanks for reading
John
Heater temperature control lever
-
Jon G 24V
- Tech Rep
- Posts: 659
- Joined: Fri Sep 07, 2018 8:05 pm
- Has thanked: 1 time
- Been thanked: 7 times
Re: Heater temperature control lever
Hi John.
There are no cable to snap mate.
Slider is just a resistance card that electrically alters the position of a Motor which in turn moves a flap.
If the Lever feels loose the you need to remove the control panel from the dash and take it apart.
Think the resistance feel comes from the contacts being spring loaded.
There are no cable to snap mate.
Slider is just a resistance card that electrically alters the position of a Motor which in turn moves a flap.
If the Lever feels loose the you need to remove the control panel from the dash and take it apart.
Think the resistance feel comes from the contacts being spring loaded.
Re: Heater temperature control lever
I think I must be having a senior moment, just drove from Leicester to Manchester and back and the heater temperature has been control able, the only thing I had done was to work the lever backward and forwards a few times with slight upwards and then downwards pressure.
So will leave well alone.
So will leave well alone.
Who is online
Users browsing this forum: No registered users and 58 guests