Engine won’t start / no spark.

Post by **LCP** » Thu Oct 10, 2019 2:25 pm

The car started no problem and then just cut out after driving about 30feet, after which it will not start again.

So far:
Distributor has been replaced and tested.
Crank Sensor has been replaced and tested.
PCM has been replaced.

There is correct voltage going to distributor/ignition coil, but nothing coming out. There is also plenty of fuel getting through

Car is 94/95 2.5v6 gt

Post by **Incognito** » Thu Oct 10, 2019 2:46 pm

Has the factory fitted immobiliser been bypassed?

Post by **Micron** » Thu Oct 10, 2019 2:47 pm

Incognito wrote: ↑
Thu Oct 10, 2019 2:46 pm
Has the factory fitted immobiliser been bypassed?

if it is an early car

Post by **mojo98** » Thu Oct 10, 2019 2:51 pm

looks to me that its a early car 94/95

Post by **Micron** » Thu Oct 10, 2019 3:04 pm

mojo98 wrote: ↑
Thu Oct 10, 2019 2:51 pm
looks to me that its a early car 94/95

good spot

Post by **fanman** » Thu Oct 10, 2019 3:09 pm

LCP wrote: ↑
Thu Oct 10, 2019 2:25 pm
The car started no problem and then just cut out after driving about 30feet, after which it will not start again.

So far:
Distributor has been replaced and tested.
Crank Sensor has been replaced and tested.
PCM has been replaced.

There is correct voltage going to distributor/ignition coil, but nothing coming out. There is also plenty of fuel getting through

Car is 94/95 2.5v6 gt

Sounds like the dizzy to me. Is the replacement dizzy new? How did you test it? If resistance in the coils is within spec then it points to the big transistor in the ignition module inside the coil having gone bad....

Post by **LCP** » Thu Oct 10, 2019 8:18 pm

Immobiliser has been removed.
Replacement Dizzy is new, and all coil resistances are within spec.

Post by **cpt black** » Fri Oct 11, 2019 7:56 am

I would re check the bypass for loose wire,does it have after market
alarm/immobiliser on it as theres only 3 circuits to shut the car down

Post by **LCP** » Fri Oct 11, 2019 1:46 pm

Thanks. I would if I could find them. However the immobiliser appears to have been totally removed. (All I can find are the bolt holes that the cage attached to)

Post by **cpt black** » Mon Oct 14, 2019 3:55 pm

You should find 2 plugs with all black wires and 3 pairs should be linked
check the links are still intact

UKPOC forums

Engine won’t start / no spark.

Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Re: Engine won’t start / no spark.

Who is online