Anyone pulled that plug apart?? Tried (gently) in hope that I can just swap the plug and reconnect/replace just the burnt out one, without going down the cutting everything route......
It’s not playing
Anyone pulled this apart......
Anyone pulled this apart......
Found problem with speedo and clocks
Anyone pulled that plug apart?? Tried (gently) in hope that I can just swap the plug and reconnect/replace just the burnt out one, without going down the cutting everything route......
It’s not playing
Anyone pulled that plug apart?? Tried (gently) in hope that I can just swap the plug and reconnect/replace just the burnt out one, without going down the cutting everything route......
It’s not playing
-
Scooby
- Registered User
- Posts: 488
- Joined: Fri Sep 21, 2018 11:49 am
- Has thanked: 4 times
- Been thanked: 3 times
Re: Anyone pulled this apart......
I bought a set of pin removal tools from ebay for a couple of quid.
Really useful for pulling individual wires from that sort of plug without destroying it completely.
You could possibly use them to remove all of the wires from the knackered connector, fix the melted wires and refit into a new plug.
Really useful for pulling individual wires from that sort of plug without destroying it completely.
You could possibly use them to remove all of the wires from the knackered connector, fix the melted wires and refit into a new plug.
Member no: 227
Location: Banks, Nr Preston, Lancs.
Drives: 2x 24V - Japha and Chewie
Location: Banks, Nr Preston, Lancs.
Drives: 2x 24V - Japha and Chewie
-
cpt black
- Tech Rep
- Posts: 2828
- Joined: Fri Sep 07, 2018 8:28 am
- Has thanked: 15 times
- Been thanked: 88 times
Re: Anyone pulled this apart......
Not done one myself Stu but if the CPU is ok 
suspect the circuit failed on the clocks (printed circuit)
It maybe possible to just cut one side off. And re solder the other connections(new block)
Is this Yours/Frags old car/now yours
suspect the circuit failed on the clocks (printed circuit)It maybe possible to just cut one side off. And re solder the other connections(new block)
Is this Yours/Frags old car/now yours
Re: Anyone pulled this apart......
Cheers all!
Gone down the cut route
Have spare clocks, so cut out the connector from breaker!
Borrowed some bits from the engineers at work, and now I have this....
In the morning disconnect all power, chop and reconnect and cross everything
Weird driving it at night with no dash or interior lights anywhere, stealth mode
Gone down the cut route
Have spare clocks, so cut out the connector from breaker!
Borrowed some bits from the engineers at work, and now I have this....
In the morning disconnect all power, chop and reconnect and cross everything
Weird driving it at night with no dash or interior lights anywhere, stealth mode
Re: Anyone pulled this apart......
Well that did it, clocks etc all working again!
Some gauges not quite sitting in normal places though, but working ok, I think!
Early oil gauge, so have to swap oil pressure switch at some point for an early one to match
Still no horn or cc tho, playing with that was what fried clocks in first place
Some gauges not quite sitting in normal places though, but working ok, I think!
Early oil gauge, so have to swap oil pressure switch at some point for an early one to match
Still no horn or cc tho, playing with that was what fried clocks in first place
Who is online
Users browsing this forum: No registered users and 107 guests