For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
-
CharlesUK
- Full Member
- Posts: 87
- Joined: Mon Feb 14, 2022 10:55 am
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Fri Feb 16, 2024 9:28 pm
Car has coil overs on at the moment that drive like concrete blocks. Looking to put stock suspension back on, should have some struts around but not on hand at the moment. Does anybody know if the strut inserts are changeable? Think would be better to refurb them unless they are welded sealed units? Or would I be better off just buying a new set for all 4 corners?
Charles.
-
Micron
- Site Admin
- Posts: 3345
- Joined: Thu Sep 06, 2018 6:08 pm
- Has thanked: 61 times
- Been thanked: 90 times
Post
by Micron » Fri Feb 16, 2024 10:18 pm
Probably quicker to buy new shocks
What inserts do you want to use as replacements?
To be honest I’m not sure if they are a DIY job to replace them?
Admin and Owner of this fine club
-
CharlesUK
- Full Member
- Posts: 87
- Joined: Mon Feb 14, 2022 10:55 am
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Fri Feb 16, 2024 10:23 pm
To be honest I have done a lot of research, was hoping to find out if it’s possible before spending hours searching and taking apart a pair.
Charles
-
Micron
- Site Admin
- Posts: 3345
- Joined: Thu Sep 06, 2018 6:08 pm
- Has thanked: 61 times
- Been thanked: 90 times
Post
by Micron » Fri Feb 16, 2024 10:25 pm
CharlesUK wrote: ↑Fri Feb 16, 2024 10:23 pm
To be honest I have done a lot of research, was hoping to find out if it’s possible before spending hours searching and taking apart a pair.
Charles
I can’t say that I have heard anyone changing inserts?
If you are looking for standard replacement ones, you can search for Mazda 626GE as they are the same.
Admin and Owner of this fine club
-
Kit
- Tech Rep
- Posts: 3551
- Joined: Fri Sep 07, 2018 8:16 pm
- Has thanked: 71 times
- Been thanked: 115 times
Post
by Kit » Sat Feb 17, 2024 12:26 am
It's not just the shock absorbers you needed.
Top mounts, strut bearing, rubber seat for the springs and springs as well.
Quicker to buy a second hand set
Kit
-
cpt black
- Tech Rep
- Posts: 2827
- Joined: Fri Sep 07, 2018 8:28 am
- Has thanked: 15 times
- Been thanked: 88 times
Post
by cpt black » Sat Feb 17, 2024 11:18 am
Could you not just slacken the coiler overs down to release tension
or are they seized
just an
-
CharlesUK
- Full Member
- Posts: 87
- Joined: Mon Feb 14, 2022 10:55 am
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Sat Feb 17, 2024 6:36 pm
Already as low as they will go, and one is seized
Charles
Who is online
Users browsing this forum: No registered users and 35 guests
