Search found 169 matches

by cpt black
Thu Dec 20, 2018 1:27 pm
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

long screw driver to check top dead center/ rear plug left hand plug/ remove and use
crankshaft bolt to turn to fully up and rotor arm should point no1 on dissy ,1 repeat till
dissy/no,1 crank should read 10/12 top dead center
by cpt black
Thu Dec 20, 2018 10:24 am
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

have you checked the battery in the fob :?: replaced :?:
by cpt black
Thu Dec 20, 2018 9:58 am
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

Back to basic,s do you have a key fob :?: to start the car ;) OEM one
Any aftermarket alarms etc added :?:
by cpt black
Tue Dec 18, 2018 4:12 pm
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

As said clean the plug,(YOU CAN DO IT) ;) it has a small tab just pull when activated
by cpt black
Mon Dec 17, 2018 3:11 pm
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

Could be the alternator taking power form the starter motor try jumping the car
with some leads
by cpt black
Sat Dec 15, 2018 6:26 am
Forum: The Garage - Technical Forum
Topic: Won't start..
Replies: 82
Views: 23585

Re: Won't start..

If a 2.5 check the Grey CPS plug by the top of the
dipstick
by cpt black
Tue Dec 11, 2018 4:48 pm
Forum: The Garage - Technical Forum
Topic: Power steering issues
Replies: 18
Views: 6027

Re: Power steering issues

You have the Tensioner mate of Boysie bring it down at the weekened
and will fit for you ,Believe we discussed it at the breaker day if i recall
and will replace with new bearing as well ;)
by cpt black
Tue Dec 11, 2018 4:02 pm
Forum: The Garage - Technical Forum
Topic: Power steering issues
Replies: 18
Views: 6027

Re: Power steering issues

Top up with some fresh fluid and check the belt tensioner
mate
by cpt black
Sun Nov 25, 2018 7:24 am
Forum: The Garage - Technical Forum
Topic: VRIS issues
Replies: 10
Views: 3421

Re: VRIS issues

Hi Gav,could be a cracked pipe under the Intake manifold from the vaccum chamber
My Vris 1 doesn,t work but engine works A1 with no problems,you could try changing
the plug over from Vris 2 to Vris1 to check
by cpt black
Wed Nov 21, 2018 6:35 pm
Forum: The Garage - Technical Forum
Topic: Heater fan
Replies: 5
Views: 2053

Re: Heater fan

You will need a new heater resistor card,located left hand side below the glove box(IN FAN UNIT)
there is 2 types early/late
4 pin in block early
4 pin in line late