For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
-
CharlesUK
- Full Member
- Posts: 104
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Sun Feb 02, 2025 5:42 pm
Hi all,
Changing nearside drive shaft, I have a replacement from J&R on eBay. I can’t get it back into the gearbox. When I take the circlip off the end its slides in effortlessly. But no matter how much I try I don’t think the clip lets is sit properly. I have attached a photo below of the join.
-
CharlesUK
- Full Member
- Posts: 104
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Sun Feb 02, 2025 6:51 pm
Update: I have put the other end back into the wheel hub and attached the tie rods. It’s all fine on that end but the gearbox side is still like this, is it correctly seated? I I thought it might have gone in further
-
jrh
- Full Member
- Posts: 1043
- Joined: Thu Sep 20, 2018 3:08 pm
- Been thanked: 44 times
Post
by jrh » Mon Feb 03, 2025 12:56 pm
Compare the two, side by side.
IF they are identical , they MUST fit the same way , nothing else will do.
-
CharlesUK
- Full Member
- Posts: 104
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 1 time
- Been thanked: 3 times
Post
by CharlesUK » Mon Feb 03, 2025 2:23 pm
Finally managed to beat it in, took shaking it around at the joint whilst friend hit from outer end with both hands. Even then still very tight!
Who is online
Users browsing this forum: Google [Bot] and 14 guests