Engine/gearbox

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Jon G 24V
Tech Rep
Posts: 658
Joined: Fri Sep 07, 2018 8:05 pm
Has thanked: 1 time
Been thanked: 6 times

Re: Engine/gearbox

Post by Jon G 24V » Wed Nov 25, 2020 5:23 pm

Good work Malc 😎

mojo98
Tech Rep
Posts: 2531
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: Engine/gearbox

Post by mojo98 » Wed Nov 25, 2020 6:02 pm

Managed to get all the engine mounts fitted,
now the hard jobs starts,
power steering pipes fitted to the pump, what a job get the PS pipe support bolt/nut back in
Right and left air bag sensors refitted.
Still mountains of work to do, :D :D

User avatar
Andy W
Full Member
Posts: 501
Joined: Thu Sep 06, 2018 11:49 pm
Has thanked: 1 time
Been thanked: 2 times

Re: Engine/gearbox

Post by Andy W » Fri Nov 27, 2020 1:29 pm

Sounds like a bit of a saga Mal.

Micron
Site Admin
Posts: 3160
Joined: Thu Sep 06, 2018 6:08 pm
Has thanked: 52 times
Been thanked: 84 times

Re: Engine/gearbox

Post by Micron » Fri Nov 27, 2020 1:46 pm

Andy W wrote: ↑
Fri Nov 27, 2020 1:29 pm
Sounds like a bit of a saga Mal.
If a certain person was still here it would have been done and dusted in 3 hours πŸ˜„πŸ˜„πŸ˜„
Admin and Owner of this fine club 😎

mojo98
Tech Rep
Posts: 2531
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: Engine/gearbox

Post by mojo98 » Fri Nov 27, 2020 3:46 pm

You could be right, but I want it doing properly
and it's not you the engine and gearbox,
I've taken of the whole of the front end,

Today's work including fitting the bottom engine support, going around the engine mount bolts making sure that I haven't missed anything,
changed the a/c catchpot on the front, that it's self was a job and a half, refitted the a/c compressor, a/c rad, power steering cooler lines, the front middle brace, bonnet lock, starter motor, then the job of sorting out all of the wire harness,
It's all the little fiddly nuts and bolts. And connections that take the time,
I may get all the wired connections done this weekend,

But its a marathon not a sprint πŸ˜‰πŸ˜‰

Micron
Site Admin
Posts: 3160
Joined: Thu Sep 06, 2018 6:08 pm
Has thanked: 52 times
Been thanked: 84 times

Re: Engine/gearbox

Post by Micron » Fri Nov 27, 2020 4:07 pm

Are you an A\C expert now then πŸ€”
Admin and Owner of this fine club 😎

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 23 guests