V6 removal of the speed sensor on the gear box?

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
el plates
Full Member
Posts: 220
Joined: Thu Sep 06, 2018 9:24 pm

V6 removal of the speed sensor on the gear box?

Post by el plates » Sun Oct 14, 2018 7:41 am

ok

sorry i imagine its got electrical leads to it????

so that gives me a choice of three....

can someone point me in the right direction.....

one at the front (radiator side) is the gearbox oil level sensor?????

then there are two at the back:

one has two wires and sits very low down on a horizontal plane,

the other is a fast easy connector, higher up next to the engine mount...

which one is the speed sensor, and are they difficult to get out......

:) :) :) :) :)

jrh
Full Member
Posts: 959
Joined: Thu Sep 20, 2018 3:08 pm
Been thanked: 36 times

Re: V6 removal of the speed sensor on the gear box?

Post by jrh » Sun Oct 14, 2018 9:10 am

Almost certain it is the one up near the engine mount.
It may be worth going to the Rockauto site and looking at the pictures of the VSS (speed) sensor.
Essentially a 'tube' ( the spiral worm gear) attached to a flange.
Looks easy to remove off the car but apparently doesn't want to move !

cpt black
Tech Rep
Posts: 2666
Joined: Fri Sep 07, 2018 8:28 am
Has thanked: 11 times
Been thanked: 82 times

Re: V6 removal of the speed sensor on the gear box?

Post by cpt black » Sun Oct 14, 2018 10:02 am

Hi Wayne its the one at the rear near the rear engine mount
2 wire connector need a 10mm socket and WD 40 spray to
loosen the seal ;)

Kit
Tech Rep
Posts: 3404
Joined: Fri Sep 07, 2018 8:16 pm
Has thanked: 65 times
Been thanked: 103 times

Re: V6 removal of the speed sensor on the gear box?

Post by Kit » Sun Oct 14, 2018 12:43 pm

The one at the front, is the reverse light switch, near the gear box oil filler/level plug.
It must have a the copper washer fitted , when put back, as this acts as a spacer, if it's missing, you can't select reverse gear :o
As we found out a few weeks ago , while working on Fluffy's car :)
Plus, you will lose some oil out the gearbox.

Kit
Last edited by Kit on Mon Oct 15, 2018 8:13 am, edited 1 time in total.

el plates
Full Member
Posts: 220
Joined: Thu Sep 06, 2018 9:24 pm

Re: V6 removal of the speed sensor on the gear box?

Post by el plates » Sun Oct 14, 2018 10:10 pm

thanks peeps, all good info.

so the front is the reverse light.

the two wire switch on the back is the speed sensor

so whats the third one with the push fit connector???

:) :) :)

jrh
Full Member
Posts: 959
Joined: Thu Sep 20, 2018 3:08 pm
Been thanked: 36 times

Re: V6 removal of the speed sensor on the gear box?

Post by jrh » Mon Oct 15, 2018 2:22 pm

Three electrical devices listed on the transaxle (gearbox).
VSS 9peed sensor
Reversing switch
PNP Park/ Neutral switch

jrh
Full Member
Posts: 959
Joined: Thu Sep 20, 2018 3:08 pm
Been thanked: 36 times

Re: V6 removal of the speed sensor on the gear box?

Post by jrh » Sun Nov 04, 2018 2:35 pm

Thanks to Wayne for the gearbox.
Off the car, the VSS sensor just pulled out, no problem.
This is the direct opposite of what all the 'scrap yards' told me, " impossible to get out", etc.
Has anyone else ever had to change one, or is it just my high mileage that revealed the problem ?

ICKLE
Site Admin
Posts: 508
Joined: Thu Sep 06, 2018 8:42 pm

Re: V6 removal of the speed sensor on the gear box?

Post by ICKLE » Sun Nov 04, 2018 3:39 pm

Actually they are a pain to get out I know becouse I have taken out a few in my time and it's either 50/50 they come out easily and in one piece or they fall apart completely when you pull them out,,,,so sounds like you were one of the lucky 50% and got one out in one piece..

jrh
Full Member
Posts: 959
Joined: Thu Sep 20, 2018 3:08 pm
Been thanked: 36 times

Re: V6 removal of the speed sensor on the gear box?

Post by jrh » Sun Nov 04, 2018 5:36 pm

Good to know, thanks.
I can imagine trying to get it out on the car is more difficult.
Is access only possible from underneath the car , or can it be done from the top ?

mojo98
Tech Rep
Posts: 2531
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: V6 removal of the speed sensor on the gear box?

Post by mojo98 » Sun Nov 04, 2018 5:47 pm

jrh wrote:
Sun Nov 04, 2018 5:36 pm
Good to know, thanks.
I can imagine trying to get it out on the car is more difficult.
Is access only possible from underneath the car , or can it be done from the top ?
I've seen it done from the top, (after taking the air box off the car)

Post Reply

Who is online

Users browsing this forum: No registered users and 40 guests