Abs code reading reports all 4 sensors!?
Abs code reading reports all 4 sensors!?
Hey,
I'm having problems pulling codes from the diagnostics box. I was using a paperclip to connect GND and TBS, then turning the ignition 2 turns. After trying it maybe 20 times the error codes were only shown twice. (They would go through the codes once, then the abs light would stay solid on.)
The codes were: 11, 12, 13, 14, then either 51 or 61.
I've checked and cleaned all 4 sensors (all have good resistance) so I'm guessing it's somewhere else. The cars had the abs light on for the past 6 years, and there's slight damage to the rear panels where I'm guessing they've checked the sensors too. So it's probably something more serious. Any help would be greatly appreciated.
Thanks,
I'm having problems pulling codes from the diagnostics box. I was using a paperclip to connect GND and TBS, then turning the ignition 2 turns. After trying it maybe 20 times the error codes were only shown twice. (They would go through the codes once, then the abs light would stay solid on.)
The codes were: 11, 12, 13, 14, then either 51 or 61.
I've checked and cleaned all 4 sensors (all have good resistance) so I'm guessing it's somewhere else. The cars had the abs light on for the past 6 years, and there's slight damage to the rear panels where I'm guessing they've checked the sensors too. So it's probably something more serious. Any help would be greatly appreciated.
Thanks,
Re: Abs code reading reports all 4 sensors!?
Hey, I took the panel off and couldn't find it. Could you post a photo?
When the diagnostics are flashing out the codes, it works for about 15 seconds, then there is a click and the abs light stays on permanently. Could this be a relay problem?
2l 1995 btw.
Thanks.
When the diagnostics are flashing out the codes, it works for about 15 seconds, then there is a click and the abs light stays on permanently. Could this be a relay problem?
2l 1995 btw.
Thanks.
Re: Abs code reading reports all 4 sensors!?
This is driving me nuts. If anyone can point me to the 1995 2l ABS control module I'll be forever in your debt.
-
- Tech Rep
- Posts: 2674
- Joined: Thu Sep 06, 2018 10:52 pm
- Location: Billingham
- Has thanked: 42 times
- Been thanked: 57 times
Re: Abs code reading reports all 4 sensors!?
Its was the passenger side panel you removed, (rear speaker panel) once off, you will need to take a piece of plastic off the body and you should see the ABS control unit plus attached to it is the remote door lock unit,
I haven't got a picture and wont have a pic for a couple of weeks with a double check one on one of mine.
I haven't got a picture and wont have a pic for a couple of weeks with a double check one on one of mine.
-
- Tech Rep
- Posts: 2674
- Joined: Thu Sep 06, 2018 10:52 pm
- Location: Billingham
- Has thanked: 42 times
- Been thanked: 57 times
Re: Abs code reading reports all 4 sensors!?
Yes that panel, then removed some rubber soundproofing then its behind that

Re: Abs code reading reports all 4 sensors!?
Got it, mojo I never should have doubted you, your both legends (I would have taken the whole dash apart.)
Is the black box the failsafe relay?
Thanks again guys, absolutely over the moon!
Is the black box the failsafe relay?
Thanks again guys, absolutely over the moon!
Who is online
Users browsing this forum: No registered users and 31 guests