Heater

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
Caprobe
Full Member
Posts: 30
Joined: Sat Mar 26, 2022 11:31 pm
Been thanked: 1 time

Heater

Post by Caprobe » Tue Dec 19, 2023 11:42 am

Hi, got a bit of a problem with the heater, it works on all speeds but no matter what position it’s set on, it only blows out the vents towards your face, all the buttons light up when individually pressed but won’t direct it to the screen, feet etc. Any idea what it could be? It’s a 2.0 no air con. Thanks

Micron
Site Admin
Posts: 3198
Joined: Thu Sep 06, 2018 6:08 pm
Has thanked: 53 times
Been thanked: 85 times

Re: Heater

Post by Micron » Tue Dec 19, 2023 12:43 pm

I would say it's one of the following things, either the controller is faulty, the blower isn't moving to the other position on the heater, the cable to either is faulty, or the pipe from the blower to the screen has become disconnected

All of which are a pain the arse to get to (within reason)
Admin and Owner of this fine club 😎

cpt black
Tech Rep
Posts: 2701
Joined: Fri Sep 07, 2018 8:28 am
Has thanked: 11 times
Been thanked: 85 times

Re: Heater

Post by cpt black » Tue Dec 19, 2023 1:43 pm

Gould be the actuator that controls the flaps in the blower unit

Caprobe
Full Member
Posts: 30
Joined: Sat Mar 26, 2022 11:31 pm
Been thanked: 1 time

Re: Heater

Post by Caprobe » Tue Dec 19, 2023 9:06 pm

Right ok thanks, think it will be easier to live with it then

cpt black
Tech Rep
Posts: 2701
Joined: Fri Sep 07, 2018 8:28 am
Has thanked: 11 times
Been thanked: 85 times

Re: Heater

Post by cpt black » Tue Dec 19, 2023 9:19 pm

you could try a new heater control module take front consul out to test(refit new one) test
then side panels with whole consul to see blower unit and see wot it does if the
actuators move

Post Reply

Who is online

Users browsing this forum: No registered users and 157 guests