Cruise control module fitting

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
notoriousgoz
Full Member
Posts: 157
Joined: Thu Sep 06, 2018 9:34 pm
Has thanked: 29 times
Been thanked: 1 time

Cruise control module fitting

Post by notoriousgoz » Mon Sep 18, 2023 7:14 pm

Can anyone give me information on how to replace the cruise module? :?: :?: 2.0 1995 probe Thanks in advance
Top
Kit
Tech Rep
Posts: 3418
Joined: Fri Sep 07, 2018 8:16 pm
Has thanked: 67 times
Been thanked: 106 times

Re: Cruise control module fitting

Post by Kit » Mon Sep 18, 2023 8:38 pm

notoriousgoz wrote: ↑
Mon Sep 18, 2023 7:14 pm
 Can anyone give me information on how to replace the cruise module? :?: :?: 2.0 1995 probe Thanks in advance
Follow the Hayes manual ;)

Never done one before,
but a few tips
Take photos of the set up before you start.
Check the replacement part is the same
Follow all the cables & wires to see where they’re connected to.
Undo these first, then unbolt unit

Kit
Top
Micron
Site Admin
Posts: 3199
Joined: Thu Sep 06, 2018 6:08 pm
Has thanked: 53 times
Been thanked: 85 times

Re: Cruise control module fitting

Post by Micron » Mon Sep 18, 2023 8:51 pm

There are about 3 nuts that need to come off, plus the plug on the front, I found that the easiest option for the cable was to remove it from the module end and take the cable and fitting on to the new one.

It shouldn’t take that long.
Admin and Owner of this fine club 😎
Top
Post Reply

Return to “The Garage - Technical Forum”

Who is online

Users browsing this forum: No registered users and 94 guests