A/C Drier Installation Probe 24v 1997
Posted: Tue Aug 17, 2021 1:23 pm
Has anyone managed to remove and replace the air conditioning drier without removing the front bumper. Any information on front bumper removal would be appreciated.
UKPOC forums
For Ford Probe enthusiasts
https://ukpoc.co.uk/forum/
A/C Drier Installation Probe 24v 1997
Page 1 of 1
Re: A/C Drier Installation Probe 24v 1997
Posted: Tue Aug 17, 2021 4:40 pm
No the front bumper cover has to come off
Re: A/C Drier Installation Probe 24v 1997
Posted: Tue Aug 17, 2021 4:46 pm
Just be carefull with the input/output lines wd 40 them so they dont twist 
Re: A/C Drier Installation Probe 24v 1997
Posted: Tue Aug 17, 2021 6:50 pm
Bumper removal
Bolts / ‘push pins’ across the front by the radiator
Two plastic screws, underneath
Two cross ties to chassis, behind the wheel splash guards
Two screws in to the wing, again behind the wheel splash guard.
Then pull it forward off the location blocks.
Don’t think I’ve missed anything
Kit
Bolts / ‘push pins’ across the front by the radiator
Two plastic screws, underneath
Two cross ties to chassis, behind the wheel splash guards
Two screws in to the wing, again behind the wheel splash guard.
Then pull it forward off the location blocks.
Don’t think I’ve missed anything
Kit
Re: A/C Drier Installation Probe 24v 1997
Posted: Mon Oct 11, 2021 8:14 am
Drier replaced. Job done! A/C works fine. These driers are a weak point in the A/C system and unfortunately are hard to get hold of. This is the second one that I have replaced on my 1997 V6 Probe.