door seals

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
paulinpoole
Full Member
Posts: 131
Joined: Sun Sep 16, 2018 6:16 pm

door seals

Post by paulinpoole » Fri Nov 06, 2020 1:38 pm

hello all :D
Can someone tell me please if its possible to remove the door seals (top of window) without taking out the rear side window ( i hope so )
i havnt tried yet but it looks like it could be tricky
any advice would be gratefully received
thanks 8-)

unpeeled & re-tealed ;)

mojo98
Tech Rep
Posts: 2529
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: door seals

Post by mojo98 » Fri Nov 06, 2020 4:03 pm

I would say yes but don't forget there are screws under the rubber top seal,
if I can get up into the loft tomorrow I will take a picture of one that's been removed 👍

cpt black
Tech Rep
Posts: 2663
Joined: Fri Sep 07, 2018 8:28 am
Has thanked: 10 times
Been thanked: 82 times

Re: door seals

Post by cpt black » Fri Nov 06, 2020 4:09 pm

As Malc said yes you can just take your time doing it ;)

Jon G 24V
Tech Rep
Posts: 658
Joined: Fri Sep 07, 2018 8:05 pm
Has thanked: 1 time
Been thanked: 6 times

Re: door seals

Post by Jon G 24V » Fri Nov 06, 2020 4:30 pm

Totally possible but as other have said there are hidden screws that require the Seal being peeled back to get to.
There are also plastic studs running up the edge f the Rear window that are also hidden.

Kit
Tech Rep
Posts: 3404
Joined: Fri Sep 07, 2018 8:16 pm
Has thanked: 65 times
Been thanked: 103 times

Re: door seals

Post by Kit » Fri Nov 06, 2020 4:35 pm

Have a good look at the pair I sent you,

There’s a mixture of screws & plastic pins that run across the top of the door

Kit

paulinpoole
Full Member
Posts: 131
Joined: Sun Sep 16, 2018 6:16 pm

Re: door seals

Post by paulinpoole » Fri Nov 06, 2020 8:14 pm

Ive seen the screw holes and plastic pin holes on the ones duncan sent me,not a problem
think i will take it steady then
great thanks a lot guys, that's a relief :)

Post Reply

Who is online

Users browsing this forum: No registered users and 40 guests