Bonnet and Flash Code

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
4PaulDerbyV6
Registered User
Posts: 3
Joined: Mon Sep 14, 2020 5:54 pm
Has thanked: 2 times

Bonnet and Flash Code

Post by 4PaulDerbyV6 » Wed Sep 23, 2020 11:29 am

I would be grateful if you have any suggestions to revive my M registered 24V Probe residing in Nottinghamshire.
The MOT is due next month
The bonnet catch does not hold the bonnet down and is on the safety mechanism. A local garage says it needs a new mechanism (not available from a Ford dealer)
A Flash Code of 13 is showing on the dash when driving
Any help, advise or suggestions would be extremely welcome
Cheers

Micron
Site Admin
Posts: 3150
Joined: Thu Sep 06, 2018 6:08 pm
Has thanked: 52 times
Been thanked: 84 times

Re: Bonnet and Flash Code

Post by Micron » Wed Sep 23, 2020 12:25 pm

if you need a replacement catch, I'm sure someone will have one from a breaker, try a post in wanted

As for code 13, where is it showing on the dash, which light?
Admin and Owner of this fine club 😎

mojo98
Tech Rep
Posts: 2522
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: Bonnet and Flash Code

Post by mojo98 » Wed Sep 23, 2020 1:39 pm

Check the spring on your bonnet catch, it may be broken, mine was and catch wouldn't close, have good look because if it was like mine covered in grease it's hard to see that it's snapped
It's easy to remove the whole of the catch to change to spring if it has snapped, couple on 10m bolts and the alarm wire connection

4PaulDerbyV6
Registered User
Posts: 3
Joined: Mon Sep 14, 2020 5:54 pm
Has thanked: 2 times

Re: Bonnet and Flash Code

Post by 4PaulDerbyV6 » Wed Sep 30, 2020 4:45 pm

Hi Micron
Thank You for your help
The Flash Code (13) is showing on the Yellow Ignition Air bag light
Thanks again
Paul

4PaulDerbyV6
Registered User
Posts: 3
Joined: Mon Sep 14, 2020 5:54 pm
Has thanked: 2 times

Re: Bonnet and Flash Code

Post by 4PaulDerbyV6 » Wed Sep 30, 2020 4:46 pm

Hi Mojo98
Thank You for your help
I'll get the spanners out!
Thanks again
Paul

mojo98
Tech Rep
Posts: 2522
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 32 times
Been thanked: 51 times

Re: Bonnet and Flash Code

Post by mojo98 » Wed Sep 30, 2020 7:53 pm

4PaulDerbyV6 wrote:
Wed Sep 30, 2020 4:45 pm
Hi Micron
Thank You for your help
The Flash Code (13) is showing on the Yellow Ignition Air bag light
Thanks again
Paul
If you joined as a full member, you can gain access to the Oracle which can help you find out answers to main problems/issues, at a cost of £10
Code 13 = airbag or front crash sensor circuit, short circuit to earth -- wiring, airbags, spiral cable, front crash sensors/safing sensor

ainsdeng
Full Member
Posts: 27
Joined: Fri Aug 07, 2020 4:50 pm

Re: Bonnet and Flash Code

Post by ainsdeng » Thu Mar 25, 2021 4:58 pm

Hi all,

Flash Code 13

I had flash code 51 which failed the MOT. I had the thermal fuse replaced and plugged the connectors in (but did not reattach unit to the chassis).

I now have flash code 13 which I assume caused the fuse to blow. One of the connectors under the driver's seat has become disattached from it and the harness loom attached to it has kinks in it but there is no visible damage. Possibly caused by the seat being moved back and trapping the loom?

Have you traced the fault to a particular circuit? Or how do I go about it without a proper wiring diagram? Or any other advice would be welcome.

Post Reply

Who is online

Users browsing this forum: No registered users and 18 guests