Page 1 of 3

Failed MOT work

Posted: Sun Sep 13, 2020 6:11 pm
by Stacey
Hi All, Hope you are all well ? My Dad owns a 16v Probe which has failed its MOT, one garage has quoted £500 to fix :/ the other garage i went to to get another quote says he is having problems sourcing the parts, Is there any particular place to get parts for them? Ideally he would like to sell it but i guess he would need to get it through the MOT first. Any advise would be greatly appreciated :) Reg is A19 DWS

Re: Failed MOT work

Posted: Sun Sep 13, 2020 6:25 pm
by Kit
Garage’s are not interested our cars.
What’s wrong with you car.
At £500 - garage prices, there can’t be a lot wrong with it :!:

Where are you based :?:

Got loads of parts here, getting them has never been an issue to me

Kit

Re: Failed MOT work

Posted: Sun Sep 13, 2020 6:33 pm
by Stacey
Hello :) thank you for your reply!

Im in Northamptonshire, My dads concern is the car probably isnt worth too much more IF £500 lol

I will list what it failed on its MOT:

parking brake lever has excessive movement
Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt offisde front inner
Suspension arm pin or bush worn - Near front inner & Offside rear
Parking brake inoperative on one side near rear
Parking brake efficiency below requirement

The biggest problem is the car sits in a garage, it has done 50 miles in the past year and wont do much this year, we know its worse for a car to sit and does more damage than good :(

Do you sell......do you fix......do you sell as spares...... i dont know lol

Re: Failed MOT work

Posted: Sun Sep 13, 2020 7:00 pm
by Kit
All easy fixes :)
Half a day’s work, if you know what your doing
Would like a bit more detail on the “worn bush”
OK , maybe new rear callipers , inspection required. There sized & until you take them apart you don’t know
Sign up to Full Membership, & May be someone might be able to help

Kit

Re: Failed MOT work

Posted: Sun Sep 13, 2020 7:44 pm
by Kit
At least there’s no welding Req :)

Kit

Re: Failed MOT work

Posted: Sun Sep 13, 2020 7:58 pm
by Micron
I also think that there isn't much wrong with it, you might be able to get some people to help out. As Duncan (Kit) says, until to strip some of it down, it's hard to tell if you need replacements or just lubricating?

What is the rest of it like, is the paint ok and the interior?

Re: Failed MOT work

Posted: Sun Sep 13, 2020 8:31 pm
by Dakota
Not failed on much I would say CV boot and pin brushes are the words jobs but obtainable bits and £500 sounds a lot of cash for just labour

Re: Failed MOT work

Posted: Mon Sep 14, 2020 7:10 pm
by Stacey
Inside needs a good clean but perfect otherwise, outside needs tlc..... Lots of tlc
Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Re: Failed MOT work

Posted: Mon Sep 14, 2020 7:16 pm
by Kit
Nice photos :)
An early 16v
Am I right in thinking, that is a rare Non-sunroof car :?:
Complete with a 90’s Mobil phone kit :o
Normal ‘dull’ Rio Red, but should polish up

Kit

Re: Failed MOT work

Posted: Mon Sep 14, 2020 7:42 pm
by mojo98
And looks like it's still got the bosch immobiliser fitted :o , I spotted the fob


All it needs is Air Con, cmon shows a picture of the engine bay :D