swapping a 1997 engine into a 1995

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
MikeyG
Full Member
Posts: 93
Joined: Thu Nov 29, 2018 6:01 pm
Has thanked: 1 time

swapping a 1997 engine into a 1995

Post by MikeyG » Sat Jun 20, 2020 11:10 pm

Hey guys,

I'm going to pull a beauty of a 97' engine and gearbox and put it into a beauty shell of a 95. Is it a case of disconnect everything, swap, connect everything, woophee? The 95 is the old immobilizer whereas the 97 is the newer one - I'll bypass the old immobilizer but could that cause any problems?

Thanks again for all your help.

Thanks,

jrh
Full Member
Posts: 959
Joined: Thu Sep 20, 2018 3:08 pm
Been thanked: 36 times

Re: swapping a 1997 engine into a 1995

Post by jrh » Sun Jun 21, 2020 8:41 am

Possibly the old distributor will have to be installed too.

Kit
Tech Rep
Posts: 3404
Joined: Fri Sep 07, 2018 8:16 pm
Has thanked: 65 times
Been thanked: 103 times

Re: swapping a 1997 engine into a 1995

Post by Kit » Sun Jun 21, 2020 9:57 am

Oil pressure sender

Need to change over the IM , if a 16v there’s differences in the wiring/plugs :o

When I swapped a early 24v into a late car there was a plug, left over around the gearbox area.
But the car ran OK

Kit

MikeyG
Full Member
Posts: 93
Joined: Thu Nov 29, 2018 6:01 pm
Has thanked: 1 time

Re: swapping a 1997 engine into a 1995

Post by MikeyG » Sun Jun 21, 2020 4:04 pm

Sorry I should have been clearer, it's a 2l to 2l. Same engine, just the 97 is so smooth but its body is rusted as heck.

The main thing was to check any immobiliser problems/do I have to bring the ECU with it?

Kit
Tech Rep
Posts: 3404
Joined: Fri Sep 07, 2018 8:16 pm
Has thanked: 65 times
Been thanked: 103 times

Re: swapping a 1997 engine into a 1995

Post by Kit » Sun Jun 21, 2020 7:36 pm

The 97 will have a temic matched ECU , but you won’t need that. Save it as a set with the ing barrel & sell it on.

Use your existing Dizzy/IM / wiring
No need to remove you ECU

Kit

MikeyG
Full Member
Posts: 93
Joined: Thu Nov 29, 2018 6:01 pm
Has thanked: 1 time

Re: swapping a 1997 engine into a 1995

Post by MikeyG » Sun Jun 21, 2020 8:48 pm

Perfect thanks. Your so helpful :)

Post Reply

Who is online

Users browsing this forum: No registered users and 43 guests