Page 1 of 2
Holes in my sills both sides at rear
Posted: Fri Jul 19, 2019 11:15 pm
by Andy kay93
Hi
Anybody had this? What sort of job is it to repair,
Could inner sills be corroded? What’s best way of checking
Sorry about all questions
Andy
Re: Holes in my sills both sides at rear
Posted: Fri Jul 19, 2019 11:31 pm
by el plates
common issue,
difficult to say, depends on the extent of rust.
any pictures.....
can only check the inners once you have cut out the rust on the outer....
most repairs are doable all depends on how deep your pockets and the overall condition of the rest of the car.
But both inner and out has been replaced before, a lot of work...
all the best
Re: Holes in my sills both sides at rear
Posted: Sat Jul 20, 2019 9:48 am
by Andy kay93
Re: Holes in my sills both sides at rear
Posted: Sun Jul 21, 2019 9:11 am
by cpt black
Not too sad wot else did they pull up on the mot
Re: Holes in my sills both sides at rear
Posted: Sun Jul 21, 2019 8:40 pm
by Andy kay93
Front to rear brake pipes
, now that’s sad
Re: Holes in my sills both sides at rear
Posted: Sun Jul 21, 2019 9:06 pm
by Andy W
been there. inners are likely to be shot too.
Re: Holes in my sills both sides at rear
Posted: Sun Jul 21, 2019 9:18 pm
by Andy kay93
Wow! That looks bad, managed to patch mine, ok for
As long as mr Mot is happy, but going forward I would
Replace sills, if only I could get some
Re: Holes in my sills both sides at rear
Posted: Tue Jul 23, 2019 11:42 pm
by Andy W
Ask Kev (CPT) when he's able to make up a batch next. They aren't a full sill but the rear sections but do fit quite nicely.
Re: Holes in my sills both sides at rear
Posted: Thu Jul 25, 2019 7:49 pm
by Andy kay93
That’s look great!, what sort of price do you think I’d
Be looking at for both sides?
Re: Holes in my sills both sides at rear
Posted: Sun Jul 28, 2019 9:57 am
by Andy W
Andy kay93 wrote: ↑Thu Jul 25, 2019 7:49 pm
That’s look great!, what sort of price do you think I’d
Be looking at for both sides?
I think it was around £60 from Kev for inners and outers when I did mine a couple of years ago.
Best ask Kev (CPT black) as it depends if he is still able to make them.
