Page 2 of 4

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 12:49 pm
by KBUK
Pads at front are newish, ebc yellow stuff. Discs were maybe a bit cheap from probestore. They didn't feel perfect since I got the driveshafts changed

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 4:42 pm
by KBUK
Image

Image

Image

Seems my car went under his. Driver side dipped more than assenger side. Exhaust tip hit the passenger side plastic bumper reinforcement. His bumper hit my radiator cross member. Think if I remove radiator this an be pulled back into place?

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 4:46 pm
by KBUK
One more part to add to list, coolant reservoir on the right side with the metal cap on top as the hose pipe at the bottom has snapped

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 5:10 pm
by cpt black
I would say the front cross member is FUBA as it,s bent back and upwards,you would need
a scrap car to cut one out and weld in then a bonnet to align for the bonnet catch and
wing alignment or use bonnet clips to hold down the bonnet, if you go the bonnet clips way
you may get away with pulling the cross member out are the wings scrapping the
doors :?:

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 5:34 pm
by KBUK
Ok guys, got radiator removed think also need rad for AC and debating to grind out then cross member and replace?

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 5:47 pm
by cpt black
You may need an A/C Rad if leaking,did my mates one when he hit a deer was,nt leaking so bent
back in shape ;) get a bonnet first and align, bonnet clips or pins will do to hold the bonnet ;)

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 6:11 pm
by KBUK
cpt black wrote:
Sat Jun 15, 2019 5:10 pm
I would say the front cross member is FUBA as it,s bent back and upwards,you would need
a scrap car to cut one out and weld in then a bonnet to align for the bonnet catch and
wing alignment or use bonnet clips to hold down the bonnet, if you go the bonnet clips way
you may get away with pulling the cross member out are the wings scrapping the
doors :?:

Wings are absolutely find apart from a tiny bend at the tip near driver light

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 6:20 pm
by cpt black
Seems you maybe lucky there mate,get a Bonnet and retro fit it to the cross member
and wnigs ;)

Re: In need of parts urgently...

Posted: Sat Jun 15, 2019 8:59 pm
by Kit
With that amount of damage :!:
Didn't the air bags go off !!

There's three crash sensor in the bumper area :?

Kit

Re: In need of parts urgently...

Posted: Sun Jun 16, 2019 1:10 pm
by KBUK
To he honest, it wasn't a bad hit. His car has a very minor scratch on the bumper. We were both braking hard so I think I went underneath and then weight of his sat on the bumper/crossmember