Rough idle

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
KEG
Registered User
Posts: 111
Joined: Thu Aug 29, 2019 3:38 pm
Has thanked: 5 times
Been thanked: 2 times

Rough idle

Post by KEG » Mon Aug 03, 2026 7:29 pm

My Probe 2.5 24v 1996 is rough idling but smooths out when driving. HT leads were changed about six months ago. Is it possibly the distributor? It’s quite old now. Or possibly a vacuum leak? Any advice is appreciated.

Micron
Site Admin
Posts: 3661
Joined: Thu Sep 06, 2018 6:08 pm
Location: South Norfolk
Has thanked: 65 times
Been thanked: 103 times

Re: Rough idle

Post by Micron » Tue Aug 04, 2026 7:52 am

How is the water level when cold and looking at the filler on the engine?
The TPS might need some adjustment, or the idle.
Dizzy's normally just fail completely, or when they get warm
Admin and Owner of this fine club 😎

Location : South Norfolk

KEG
Registered User
Posts: 111
Joined: Thu Aug 29, 2019 3:38 pm
Has thanked: 5 times
Been thanked: 2 times

Re: Rough idle

Post by KEG » Tue Aug 04, 2026 2:08 pm

Water level is good.
No poor acceleration: The car does not hesitate or jerks when I press the accelerator. No stalling. The car does not unexpectedly shut off while driving or stopping. Just rough idling and a slight thud sound. The rev counter does not deviate much at all only slightly on occasions.

andy p
Full Member
Posts: 324
Joined: Thu Oct 28, 2021 10:49 am
Has thanked: 1 time
Been thanked: 11 times

Re: Rough idle

Post by andy p » Tue Aug 04, 2026 4:38 pm

You're not putting E10 fuel in her? Mine got lumpy idle the only time I used it. I always use the expensive stuff now.

KEG
Registered User
Posts: 111
Joined: Thu Aug 29, 2019 3:38 pm
Has thanked: 5 times
Been thanked: 2 times

Re: Rough idle

Post by KEG » Tue Aug 04, 2026 7:13 pm

No. Shell V Power.

Micron
Site Admin
Posts: 3661
Joined: Thu Sep 06, 2018 6:08 pm
Location: South Norfolk
Has thanked: 65 times
Been thanked: 103 times

Re: Rough idle

Post by Micron » Thu Aug 06, 2026 9:33 am

It could be a split in the elbow between the VAF and IM, or a pipe has come off at the back of the air box.
Is your car a standard set up, have you changed anything recently?
Do you have any oil in the plug wells
Where are you based
Admin and Owner of this fine club 😎

Location : South Norfolk

KEG
Registered User
Posts: 111
Joined: Thu Aug 29, 2019 3:38 pm
Has thanked: 5 times
Been thanked: 2 times

Re: Rough idle

Post by KEG » Fri Aug 07, 2026 7:02 pm

Standard set up. Located in Gosport Hampshire. Not changed anything. Have a small rocker cover oil leak.

Micron
Site Admin
Posts: 3661
Joined: Thu Sep 06, 2018 6:08 pm
Location: South Norfolk
Has thanked: 65 times
Been thanked: 103 times

Re: Rough idle

Post by Micron » Fri Aug 07, 2026 11:03 pm

Have you checked all of your pipes etc?
When you say the water is ok, is it full to the brim when you remove the cap on the engine, with it not running and the engine is cold?

Have you checked for any fault codes

Are you able to share a video of it doing it?
Admin and Owner of this fine club 😎

Location : South Norfolk

KEG
Registered User
Posts: 111
Joined: Thu Aug 29, 2019 3:38 pm
Has thanked: 5 times
Been thanked: 2 times

Re: Rough idle

Post by KEG » Sun Aug 09, 2026 5:20 pm

Pipes ok. As far as I can tell. Water is full to the brim. Not checked fault codes as that is beyond me. I could share a video.
Will do later. Car going in for service tomorrow, and exploration of this issue. Might know more then.

Post Reply

Who is online

Users browsing this forum: No registered users and 47 guests