Hi all,
Swapping previous owners coil overs back to original and can’t seem to get the strut into the knuckle. The coil over was lined up perfectly with it, but after putting the top studs through their mounting point this new strut seems to sit so far below the knuckle even after compressing the strut somewhat I couldn’t get it on. I bought them off a 1992 Mazda 626, I believe these fit?
Charles
Rear shocks/ struts
-
Micron
- Site Admin
- Posts: 3391
- Joined: Thu Sep 06, 2018 6:08 pm
- Location: South Norfolk
- Has thanked: 62 times
- Been thanked: 90 times
Re: Rear shocks/ struts
I believe that they have to be a 626GE, but I’m not sure what year the GE came out?
Admin and Owner of this fine club 
Location : South Norfolk
Location : South Norfolk
-
CharlesUK
- Full Member
- Posts: 99
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 1 time
- Been thanked: 3 times
Re: Rear shocks/ struts
The advert is listed at GE, but wasn’t 100% sure as I believe that’s the year it crossed over. I have attached the link below.
https://www.ebay.co.uk/itm/156506570797
https://www.ebay.co.uk/itm/156506570797
-
Micron
- Site Admin
- Posts: 3391
- Joined: Thu Sep 06, 2018 6:08 pm
- Location: South Norfolk
- Has thanked: 62 times
- Been thanked: 90 times
Re: Rear shocks/ struts
Are you able to measure any fixed points between the coil overs and standard shocks to see if there is a difference?
I might have some rear shocks, but no access until at least the weekend.
Where are you based?
I might have some rear shocks, but no access until at least the weekend.
Where are you based?
Admin and Owner of this fine club
Location : South Norfolk
Location : South Norfolk
Who is online
Users browsing this forum: No registered users and 36 guests