hi all, bit of a mystery
tonight i got out the car to open my garage door & the interior lights came on as usual, when i got back in car the lights didn't go off, i opened & closed doors boot bonnet but they wont go off, there was also a burning smell in the car, pulled the roof bulb out they all went out then flickered and the footwell ones came back on & wouldn't go off, put the bulb in & out again, now nothing, i put the car in the garage & disconnected the battery for now, for battery drain or worse.
Is there a module for the interior lights somewhere ? or is it all controlled inc dimmer in the roof interior light
where is the fuse ? i can pull out for now, under the bonnet or is it on the inside fuse panel
Any ideas anyone, thanks in advance
interior lights update
-
paulinpoole
- Full Member
- Posts: 167
- Joined: Sun Sep 16, 2018 6:16 pm
- Been thanked: 1 time
interior lights update
Last edited by paulinpoole on Sat Nov 16, 2024 2:15 pm, edited 1 time in total.
-
paulinpoole
- Full Member
- Posts: 167
- Joined: Sun Sep 16, 2018 6:16 pm
- Been thanked: 1 time
Re: interior lights
Thanks Dunc
On investigation today i checked all wiring (i can get too) everything that's connected to that circuit, one by one unplugging & trying, stereo, clock, under bonnet light, boot light, roof/map light, sun visor vanity lights. Everything is ok. Except for the glovebox bulb which seems dead when tried new bulbs.( past post on forum)
Can someone tell me what makes the interior boot light come on when you open the boot please, i found 2 wires connected to the latch, disconnected the plug,tried it with no difference,but dont know if thats for the boot light or central locking.
And completely disconnected the extra LED lights i connected up to the circuit ( thinking i could of overloaded the circuit or a earthing fault )
At the end of this i was looking at the fusebox/cpu kit said about and i found this
so there was a problem and ive disconnected the extra lights i put in, so back to the standard car wiring now, so should be fine.
has anyone got this cpu/fusebox part they can sell me pretty please, kit ?
will put a post in wanted section.
On investigation today i checked all wiring (i can get too) everything that's connected to that circuit, one by one unplugging & trying, stereo, clock, under bonnet light, boot light, roof/map light, sun visor vanity lights. Everything is ok. Except for the glovebox bulb which seems dead when tried new bulbs.( past post on forum)
Can someone tell me what makes the interior boot light come on when you open the boot please, i found 2 wires connected to the latch, disconnected the plug,tried it with no difference,but dont know if thats for the boot light or central locking.
And completely disconnected the extra LED lights i connected up to the circuit ( thinking i could of overloaded the circuit or a earthing fault )
At the end of this i was looking at the fusebox/cpu kit said about and i found this
so there was a problem and ive disconnected the extra lights i put in, so back to the standard car wiring now, so should be fine.
has anyone got this cpu/fusebox part they can sell me pretty please, kit ?
will put a post in wanted section.
-
paulinpoole
- Full Member
- Posts: 167
- Joined: Sun Sep 16, 2018 6:16 pm
- Been thanked: 1 time
Re: interior lights update
I’ve got my ecu from kit (thanks mate) however I have not put it in yet, the fuse is out for now, but now I have the door open warning light on dash even tho all doors boot & bonnet are shut
I don’t want to put in the new ecu untill I know it’s safe to.
I know the door switches are fine, can someone tell me how the interior lighting is activated when the bonnet & boot are opened as there’s no courtesy switches like on the doors, thank you
update, after going through all the possibilities again & finding nothing wrong i put in the ecu and all seems good, fingers crossed
Q so ... how does the interior courtesy lighting work on the boot & bonnet ? is it in the latch ? be interesting to know
I don’t want to put in the new ecu untill I know it’s safe to.
I know the door switches are fine, can someone tell me how the interior lighting is activated when the bonnet & boot are opened as there’s no courtesy switches like on the doors, thank you
update, after going through all the possibilities again & finding nothing wrong i put in the ecu and all seems good, fingers crossed
Q so ... how does the interior courtesy lighting work on the boot & bonnet ? is it in the latch ? be interesting to know
-
mr moo
- Full Member
- Posts: 80
- Joined: Tue Sep 11, 2018 9:50 am
- Has thanked: 15 times
- Been thanked: 4 times
Re: interior lights update
The boot and bonnet lighting are switched by micro switches in the latch. They switch a plain earth, which also arms and triggers the factory alarm. The CPU controls the interior light in a different way. The earth and line circuit for the light is within the CPU and switched via transistors and capacitors for the fade off, the switching is via a switched earth courtesy of the door switch. If you take a live or earth to power footwell lights from anywhere else other than the two supply wires to the roof interior light and connect one to the door switch you will create a short that will fry your CPU.
Either that or one wire has shorted to the other or to ground. Nothing about the probe wiring is 'traditional'!
Either that or one wire has shorted to the other or to ground. Nothing about the probe wiring is 'traditional'!
-
paulinpoole
- Full Member
- Posts: 167
- Joined: Sun Sep 16, 2018 6:16 pm
- Been thanked: 1 time
Re: interior lights update
wow that is pretty deepmr moo wrote: ↑Thu Nov 21, 2024 11:23 pmThe boot and bonnet lighting are switched by micro switches in the latch. They switch a plain earth, which also arms and triggers the factory alarm. The CPU controls the interior light in a different way. The earth and line circuit for the light is within the CPU and switched via transistors and capacitors for the fade off, the switching is via a switched earth courtesy of the door switch. If you take a live or earth to power footwell lights from anywhere else other than the two supply wires to the roof interior light and connect one to the door switch you will create a short that will fry your CPU.
Either that or one wire has shorted to the other or to ground. Nothing about the probe wiring is 'traditional'!
thanks for that 
the door switches using a earth wire sounds how ive always known, but never had any doings with micro switches in latches before.
i did wire in the extra led,s directly off the back terminals off the boot courtesy light so there would be no possibility of shorts but thats disconnected now, possibly overloaded the CPU i dont know, but its back to stock now.
years back i disconnected the wires on bonnet latch as the alarm kept sounding as i had a faulty central locking relay but that was put right with a used relay from kit (duncan)
thanks for the info, always good to learn something new
Who is online
Users browsing this forum: No registered users and 25 guests