Search found 115 matches

by mojo98
Sun Aug 18, 2019 10:22 pm
Forum: The Garage - Technical Forum
Topic: windscreen washer warning light
Replies: 5
Views: 68

Re: windscreen washer warning light

As above,my warning light has come on,so i topped up both reservoir and the light is still on where will i find the sensor/switch that illuminates the light ? thanks 8-) UNPEELED & RETEALED ;) Paul its inside the wash bottle its self, drivers wheel off, take off the plastic liner from inside the wh...
by mojo98
Thu Aug 08, 2019 11:00 pm
Forum: The Garage - Technical Forum
Topic: Steering wheel click
Replies: 4
Views: 53

Re: Steering wheel click

Could be the Strut top bearing, they are only thin pieces of plastic the grease between them and when they dry out its makes a clicking noise when turning the wheel, (my daily runner does it) I`ve got the bearing`s but not had time to change them
by mojo98
Wed Aug 07, 2019 8:07 pm
Forum: The Garage - Technical Forum
Topic: Spark Plug Replacement
Replies: 1
Views: 39

Re: Spark Plug Replacement

I use Motorcraft plugs, :D have used NGK`s in the passed and were ok
by mojo98
Fri Aug 02, 2019 11:26 am
Forum: The Garage - Technical Forum
Topic: Gearbox oil change
Replies: 2
Views: 79

Re: Gearbox oil change

Hi Andy, here is a write up on what to do

https://www.ukpoc.co.uk/forum/viewtopic ... =425#p2764
by mojo98
Wed Jul 31, 2019 8:31 pm
Forum: The Garage - Technical Forum
Topic: emissions
Replies: 11
Views: 179

Re: emissions

Change the Spark Plugs, Air Fliter pull the Codes may need to O2 sensors I`ve never used any additives, Few year ago one of my probes was just passed on emission, and the test told me to get my engine tuned, but i didnt and the next year it flew thro the emissions, the tester asked me what i did, to...
by mojo98
Sat Jul 27, 2019 10:28 pm
Forum: The Garage - Technical Forum
Topic: Breakdown
Replies: 15
Views: 267

Re: Breakdown

Like Justin says, its a easy fix,, radiator out, But I did mine from below without managing to remove the radiator, Just remember to undo the locking nut on the belt system,
whole job should take less than 1 hour :D
by mojo98
Thu Jul 25, 2019 4:51 pm
Forum: The Garage - Technical Forum
Topic: Rear suspension compatibility
Replies: 1
Views: 69

Re: Rear suspension compatibility

The trouble is suppliers and even Mazda dealerships will say not compatible, but they either dont know that the ford probe is build on the Mx6 platform (GE Platform0 I have ordered parts off my local Mazda dealer but if i give them my probe reg, they wont order the parts, so I give them a MX 6 reg, ...
by mojo98
Mon Jul 22, 2019 10:31 am
Forum: The Garage - Technical Forum
Topic: Bosh Immobiliser- by pass Ford Probe 16V
Replies: 7
Views: 192

Re: Bosh Immobiliser- by pass Ford Probe 16V

Hi Car running fine now- no immobiliser or fob anymore. Thank you for giving me the confidence to do the surgery!! Geoff Shaw That`s what this club is all about, helping other members to keep these cars on the road (well done to all who gave advise) Geoff have you considered becoming a full member ...
by mojo98
Thu Jul 18, 2019 9:08 am
Forum: The Garage - Technical Forum
Topic: Pedal rubbers
Replies: 1
Views: 72

Re: Pedal rubbers

Have you tried a local Autoparts they may be able to help :D
by mojo98
Fri Jun 14, 2019 9:06 pm
Forum: The Garage - Technical Forum
Topic: Abs code reading reports all 4 sensors!?
Replies: 8
Views: 422

Re: Abs code reading reports all 4 sensors!?

MikeyG wrote:
Fri Jun 14, 2019 9:03 pm
Behind this panel?


Image

Think I'm going a little loopy.
Yes that panel, then removed some rubber soundproofing then its behind that :D