Engine/gearbox

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Jon G 24V
Tech Rep
Posts: 527
Joined: Fri Sep 07, 2018 8:05 pm
Been thanked: 5 times

Re: Engine/gearbox

Post by Jon G 24V » Wed Nov 25, 2020 5:23 pm

Good work Malc ๐Ÿ˜Ž

mojo98
Area Rep
Posts: 1513
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 6 times
Been thanked: 13 times

Re: Engine/gearbox

Post by mojo98 » Wed Nov 25, 2020 6:02 pm

Managed to get all the engine mounts fitted,
now the hard jobs starts,
power steering pipes fitted to the pump, what a job get the PS pipe support bolt/nut back in
Right and left air bag sensors refitted.
Still mountains of work to do, :D :D

User avatar
Andy W
Full Member
Posts: 435
Joined: Thu Sep 06, 2018 11:49 pm
Been thanked: 2 times

Re: Engine/gearbox

Post by Andy W » Fri Nov 27, 2020 1:29 pm

Sounds like a bit of a saga Mal.

Micron
Site Admin
Posts: 1258
Joined: Thu Sep 06, 2018 6:08 pm
Been thanked: 11 times

Re: Engine/gearbox

Post by Micron » Fri Nov 27, 2020 1:46 pm

Andy W wrote: โ†‘
Fri Nov 27, 2020 1:29 pm
Sounds like a bit of a saga Mal.
If a certain person was still here it would have been done and dusted in 3 hours ๐Ÿ˜„๐Ÿ˜„๐Ÿ˜„

mojo98
Area Rep
Posts: 1513
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 6 times
Been thanked: 13 times

Re: Engine/gearbox

Post by mojo98 » Fri Nov 27, 2020 3:46 pm

You could be right, but I want it doing properly
and it's not you the engine and gearbox,
I've taken of the whole of the front end,

Today's work including fitting the bottom engine support, going around the engine mount bolts making sure that I haven't missed anything,
changed the a/c catchpot on the front, that it's self was a job and a half, refitted the a/c compressor, a/c rad, power steering cooler lines, the front middle brace, bonnet lock, starter motor, then the job of sorting out all of the wire harness,
It's all the little fiddly nuts and bolts. And connections that take the time,
I may get all the wired connections done this weekend,

But its a marathon not a sprint ๐Ÿ˜‰๐Ÿ˜‰

Micron
Site Admin
Posts: 1258
Joined: Thu Sep 06, 2018 6:08 pm
Been thanked: 11 times

Re: Engine/gearbox

Post by Micron » Fri Nov 27, 2020 4:07 pm

Are you an A\C expert now then ๐Ÿค”

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests