Rear lateral control arm bolt
Rear lateral control arm bolt
Hey guys,
Not even sure what I'm hoping for but this nut is driving me crazy. Its the left rear lateral control arm. Its rounded, and I cant get an angle grinder/hacksaw anywhere near it because of the ridiculous shaped metal around it. I'm not sure what response I'm looking for, even just a few positive words of encouragement or a subtle compliment might help it come loose.
Thanks,
-
- Tech Rep
- Posts: 2588
- Joined: Thu Sep 06, 2018 10:52 pm
- Has thanked: 40 times
- Been thanked: 54 times
Re: Rear lateral control arm bolt
agree not the best place to try and remove the bolt from,
only tried once but couldn`t remove it, but at the time it didn`t matter as i was breaking the car, so that was the only part i left on the car, i know that doesn`t help you but
have you tried heating up the nut ?
only tried once but couldn`t remove it, but at the time it didn`t matter as i was breaking the car, so that was the only part i left on the car, i know that doesn`t help you but
have you tried heating up the nut ?
-
- Tech Rep
- Posts: 2735
- Joined: Fri Sep 07, 2018 8:28 am
- Has thanked: 14 times
- Been thanked: 85 times
Re: Rear lateral control arm bolt
Use a nut splitter to crack it and then turn the bolt and split on the opposite side
or just drill the nut if you don't have one,i was lucky and got mine off but I wd 40,d
mine for 2 weeks then used a breaker bar wedged on the floor and a socket on the bolt
or just drill the nut if you don't have one,i was lucky and got mine off but I wd 40,d
mine for 2 weeks then used a breaker bar wedged on the floor and a socket on the bolt
Re: Rear lateral control arm bolt
Its right beside the fuel tank so I'm not comfortable heating it up.mojo98 wrote: ↑Mon Aug 26, 2019 7:32 amagree not the best place to try and remove the bolt from,
only tried once but couldn`t remove it, but at the time it didn`t matter as i was breaking the car, so that was the only part i left on the car, i know that doesn`t help you but
have you tried heating up the nut ?
The nut splitter is a good idea, I'll try that tomorrow.
Who is online
Users browsing this forum: No registered users and 109 guests